Can anybody tell me how I can setup where every time somebody creates a
CAD part that it will use my Lifecycle and Workflows that I created
rather than the Basic Lifecycle preinstalled in Windchill? This would
seem a simple thing or a common thing but I can't find anything that
describes this process. Maybe I'm thinking in the wrong mind set just
from the lack of Windchill knowledge. I called PTC support last week
and the guy said he didn't know and would have to get back to me maybe
Tuesday of next week. I'm hoping somebody here would have an answer
because I can't wait until PTC gets there act together.
CAD part that it will use my Lifecycle and Workflows that I created
rather than the Basic Lifecycle preinstalled in Windchill? This would
seem a simple thing or a common thing but I can't find anything that
describes this process. Maybe I'm thinking in the wrong mind set just
from the lack of Windchill knowledge. I called PTC support last week
and the guy said he didn't know and would have to get back to me maybe
Tuesday of next week. I'm hoping somebody here would have an answer
because I can't wait until PTC gets there act together.