I am trying to recreate the Blend the Three Tubes tutorial from PTC. I had to recreate the basic tubes and then create the surfaces on the outside of each. Then, create the points, hence the need for the angled Datum Planes.
View attachment 27
In trying to follow the instructions on page 7-16, (the fan shape) Pro/E tells me it cannot create the geometry. Of course, I cannot use the point numbers as mine are different. And, the points that highlite are diffderent from the Datum Points that I created.
View attachment 28
When I do the second dir, the points that highlite are between the two points on the handle of the fan. I can create two pieces of boarder, but it still does not work.
Any suggestions?
Roger
View attachment 27
In trying to follow the instructions on page 7-16, (the fan shape) Pro/E tells me it cannot create the geometry. Of course, I cannot use the point numbers as mine are different. And, the points that highlite are diffderent from the Datum Points that I created.
View attachment 28
When I do the second dir, the points that highlite are between the two points on the handle of the fan. I can create two pieces of boarder, but it still does not work.
Any suggestions?
Roger