Hi every one!
Does any one know or have a naming convention for screws?
I am doing my naming as follows: SC-6-32-24-FA where:
SC denotes screw
6-32 denotes the thread call
24 denotes the length in xx/32 of an inch
FA denotes Flat head and allen wrench cavity.
Do you think this is too much "fuzz"?
Thank you.
Edited by: ivan sosa
Does any one know or have a naming convention for screws?
I am doing my naming as follows: SC-6-32-24-FA where:
SC denotes screw
6-32 denotes the thread call
24 denotes the length in xx/32 of an inch
FA denotes Flat head and allen wrench cavity.
Do you think this is too much "fuzz"?
Thank you.
Edited by: ivan sosa