i am missing something while trying to make a drawing of an exploded assembly view, in assembly mode i just edit the explode positions to an optimum view position, then i create a new drawing with the assembly as a model.
when inserting a new drawing view into the sheet, i got to check the exploded option, when doing that i got a checkbox with a 'default' option in it, if unchecked the view i get is unexploded, if checked the view i get is exploded but with the default explode status proe did for the assembly, not the one i edited.
how should i transfer this position status with the model to get the same edited exploded view in the drawing?
i am using proe wildfire 2.0
thanks.
shady.
when inserting a new drawing view into the sheet, i got to check the exploded option, when doing that i got a checkbox with a 'default' option in it, if unchecked the view i get is unexploded, if checked the view i get is exploded but with the default explode status proe did for the assembly, not the one i edited.
how should i transfer this position status with the model to get the same edited exploded view in the drawing?
i am using proe wildfire 2.0
thanks.
shady.