Hi folks.
We're getting a sub-con to produce a bunch of legacy parts & drawings in Pro/E.
The thing is - we use Intralink (with revision, version, etc) but they don't have a license...
The drawing format has fields for &proi_revision + &proi_version - but when you use it outside Intralink these just turn to ***.
If you try to create parameters with these names, you get the message:
This name is reserved
Short of loaning them a license of Intralink, how could we get these parameters entered & populated with the relevant values?
I suppose the other alternative is to leave them blank & replace the formats when we get them into Intralink.
Thanks in advance for your thoughts.
Ed
We're getting a sub-con to produce a bunch of legacy parts & drawings in Pro/E.
The thing is - we use Intralink (with revision, version, etc) but they don't have a license...
The drawing format has fields for &proi_revision + &proi_version - but when you use it outside Intralink these just turn to ***.
If you try to create parameters with these names, you get the message:
This name is reserved
Short of loaning them a license of Intralink, how could we get these parameters entered & populated with the relevant values?
I suppose the other alternative is to leave them blank & replace the formats when we get them into Intralink.
Thanks in advance for your thoughts.
Ed