To apply by rule filter to Automaic BOM one usually writes following relation
asm.mbr.type== part (to keep only parts in BOM)
or
asm.mbr.type== assembly (to keep only assemblies in BOM)
My question is ;I want keep only components. To further elaborate my question;
Suppose I have an assembly which has two subassemblies and three parts as components (total five components), I want my BOM to display only these 5 components.
How can I do this? There is no such default parameter as "component" instad of "part" or "assembly" .
My other question is that my BOM table has 3 decimal places e.g. 45.327
I have set my configuration option
default_decimal_places 2
but this does not work.
I am using WF 2.0 M090
Thanks for help.
Israr
asm.mbr.type== part (to keep only parts in BOM)
or
asm.mbr.type== assembly (to keep only assemblies in BOM)
My question is ;I want keep only components. To further elaborate my question;
Suppose I have an assembly which has two subassemblies and three parts as components (total five components), I want my BOM to display only these 5 components.
How can I do this? There is no such default parameter as "component" instad of "part" or "assembly" .
My other question is that my BOM table has 3 decimal places e.g. 45.327
I have set my configuration option
default_decimal_places 2
but this does not work.
I am using WF 2.0 M090
Thanks for help.
Israr