I have an assembly where I want only one part as a sectioned view. This
way it should be easier to see the parts that are behind my sectioned
part.
Note : I want it to be done in assembly mode, not in the drawing mode.
From the view manager I can select a sectioned view and then select
part instead of assy, but that results in a view I cannot set active
Any suggestions ?
Using WF2.0
way it should be easier to see the parts that are behind my sectioned
part.
Note : I want it to be done in assembly mode, not in the drawing mode.
From the view manager I can select a sectioned view and then select
part instead of assy, but that results in a view I cannot set active
Any suggestions ?
Using WF2.0