I have a box that I modeled only 1/4 of it for the analysis.
There are many weldsin the supports in the assembly. If I free up
the translations in the plane of the cut, it gives me an error trying
to delete the constraints. Because it is 1/4 of the model, I have
this on both the top and the side.
Anyone know why? I have a pic that I can send to anyone wanting to look at it.
Thanks,
Tim
2005-06-22_095933_initialtest.zip
Edited by: alfordtp
There are many weldsin the supports in the assembly. If I free up
the translations in the plane of the cut, it gives me an error trying
to delete the constraints. Because it is 1/4 of the model, I have
this on both the top and the side.
Anyone know why? I have a pic that I can send to anyone wanting to look at it.
Thanks,
Tim
2005-06-22_095933_initialtest.zip
Edited by: alfordtp