Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
In the view manager, all tab. Create a new combined state. When having a combined state, select edit. Here you can select simp rep, section, orientation. Play around with it. I'm not to good at this and I lost a lagre drawing when deleting a combined state when the drawing was not in session. The drawing became uinretrivable when it could not find the combined state.
It is for a part, and only one part!!! I'm using WF4, but could do this in WF3 also. Don't know about WF2 and earlier.
Here is a part with4 features
I then make 3simp rep turning these features on/of, and I must make 3 comb_states that do the same. (but you can ad more like different orientation, section or not.) When I insert a general view, I get a dialog box as shown in earlier post, but with names you set for the combined states. Below is a drawing showing master rep and my three comb states.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.