design-engine
New member
I have played with the repeat regions some. Certainly confused some. Maybe I could start a thread as to how to set that up on an assembly from the beginning.
Build a table. Designate the table. Add mbr.name type info. Not sure what each variable does but can take it out of context when entering them....
This is from PTC help
Define a Repeat Region
1. Click Table > Repeat Region. The Menu Manager opens.
2. Click Add. You are prompted to select the corners of the region.
3. Click the lower-left cell, then the lower-right cell. Both cells are
highlighted. Click OK, then Done on the Menu Manager.
Now you are ready to enter the parameters for the assembly index
number and matching part name.
Add BOM Parameters
1. Double-click the left side cell of the repeat region. Because it is now a
repeat region, the Report Symbol menu opens by default. These are
the top-level prefixes, denoting the modules for which reports may
be generated. This menu lets you assemble a report parameter string
by
Build a table. Designate the table. Add mbr.name type info. Not sure what each variable does but can take it out of context when entering them....
This is from PTC help
Define a Repeat Region
1. Click Table > Repeat Region. The Menu Manager opens.
2. Click Add. You are prompted to select the corners of the region.
3. Click the lower-left cell, then the lower-right cell. Both cells are
highlighted. Click OK, then Done on the Menu Manager.
Now you are ready to enter the parameters for the assembly index
number and matching part name.
Add BOM Parameters
1. Double-click the left side cell of the repeat region. Because it is now a
repeat region, the Report Symbol menu opens by default. These are
the top-level prefixes, denoting the modules for which reports may
be generated. This menu lets you assemble a report parameter string
by