At my last job I had a document that was the easiest way to create spur gears using curves from equation. All you had to do was copy and past the formula into the Equation editor and it would generate the involute curve. All you had to do was change the Diametral pitch number and the number of teeth and you were good to go. It had equations for both adding and removing material for both inside and outside gears.
I seam to have lost this document (can't remember if it was a word document or a PDF) and I seam to remember getting it from this website.
If anyone happens to have this document I would really appreciate getting it again. It was the best thing for gears since sliced bread!!
Thanks in Advance!
Scott Monday
I seam to have lost this document (can't remember if it was a word document or a PDF) and I seam to remember getting it from this website.
If anyone happens to have this document I would really appreciate getting it again. It was the best thing for gears since sliced bread!!
Thanks in Advance!
Scott Monday