gabrielferaru
New member
Hi!
I have a simple harness: one connector and one wire loop on this connector.
The wire named 555 looks ok on harnessassembly. The wire starts on pin 2 and ends on pin 5.
But, on harness drawing, on my "wire table" the 555-wire is reported wrong. The both ends for this wire are on the pin 2.
Where is the mistake?
I have a simple harness: one connector and one wire loop on this connector.
The wire named 555 looks ok on harnessassembly. The wire starts on pin 2 and ends on pin 5.
But, on harness drawing, on my "wire table" the 555-wire is reported wrong. The both ends for this wire are on the pin 2.
Where is the mistake?