MartinBooker
New member
I have a 2 piece assembly as in the picture below.
The grey 'shroud' item is assembled with its end face 'A' flush with the end face of the green shaft, face 'B'.
If I measure the distance 'Surface to Surface' from face 'A' to face 'B' I get a result of "0.0000" as you would expect - The two faces are flush.
A measurement from face 'C' to face 'B' (both end faces of the same part) returns "12.125".
Measuring from face 'C' to face 'A' (end face of shaft to end face of shroud) returns "12.150".
Thats 0.025" difference !!!!
Has anyone else experienced this potentially dangerous bug ?
View attachment 2330
The grey 'shroud' item is assembled with its end face 'A' flush with the end face of the green shaft, face 'B'.
If I measure the distance 'Surface to Surface' from face 'A' to face 'B' I get a result of "0.0000" as you would expect - The two faces are flush.
A measurement from face 'C' to face 'B' (both end faces of the same part) returns "12.125".
Measuring from face 'C' to face 'A' (end face of shaft to end face of shroud) returns "12.150".
Thats 0.025" difference !!!!
Has anyone else experienced this potentially dangerous bug ?
View attachment 2330