Hi all,
I have a cap with three lugs @ 120degrees. I want to create a x-section in view manager using a sketch going through the lugs, but i can't get it to show in the drawing unfolded, so that you see the full width of the part. The one half is a projection of the cut surface.
Anyone can help me out?
TIA
Sip
Edited by: sip
I have a cap with three lugs @ 120degrees. I want to create a x-section in view manager using a sketch going through the lugs, but i can't get it to show in the drawing unfolded, so that you see the full width of the part. The one half is a projection of the cut surface.
Anyone can help me out?
TIA
Sip
Edited by: sip