Tool Vibration

[leow_john]

Hi all'

Hope you not feeling bad to me since I am posting many doubts recently.

I would like to ask you all a general question.

I notice my tool get vibrated while machining in corners of a pocket

Any method to over come

 

[dibz]

Hi
u can use corner round redius value to specify a corner radius. so that there r no sharp corners.

or use the parameter corner slowdown to slow down feed rate at sharp corners

 

[wsylvester]

try to always have a littlecircular move in your corners when you can


avoid 90

 

[wsylvester]

also read this


[url]http://www.mcadcentral.com/articles/templates/proe.asp?artic leid=2&zoneid=2[/url]

 

[dbrainsky]

Hi,


With Wildfire 3.0 thereare parameters within the Volume and Roughing nc-sequences that allows for this condition. If set the cldata will output a different feedrate before any type ofcorners. Why these are not included with the profile nc-sequence yet is disturbing.


CORNER_SLOWDOWN


SLOWDOWN_LENGTH


SLOWDOWN_PERCENT


NUMBER_SLOWDOWN_STEPS


All designed to correct yor problem.

 

[wsylvester]

Leow,


on methods you might want to look around at this site


http://www.mmsonline.com