I need to put extruded type on a curved surface. Not sure how to do it, on a flat one is easy. Here is the model if you have an answer.
2006-04-08_032438_22mm_petcock-stem.zip
Also, when I print a drawing, all of the lines and type on the titlesheet (that was from the format template) as well as some dimensions, and the profile linesprint very fat lines and get unreadable. But the dimensions from the layout viewports come out very thin, whereas the dimensions that I add come out fat.
I think this is a difference between paperspace and modelspace, but I could be wrong. How can I make all of the lines and type thin lines so they are readable?
I have Pro-E Wildfire.
Thanks for any assistance.
2006-04-08_032438_22mm_petcock-stem.zip
Also, when I print a drawing, all of the lines and type on the titlesheet (that was from the format template) as well as some dimensions, and the profile linesprint very fat lines and get unreadable. But the dimensions from the layout viewports come out very thin, whereas the dimensions that I add come out fat.
I think this is a difference between paperspace and modelspace, but I could be wrong. How can I make all of the lines and type thin lines so they are readable?
I have Pro-E Wildfire.
Thanks for any assistance.