Hey guys,
I have searched and read, and read and searched some more and haven't been able to figure out how to do this. I have a strain relief bushing that is modeled up as it comes from the mold, but now I want to bend it into an 'installed' position. Is a spinal bend the right option for this? Any help would be greatly appreciated! The link below is to the actual part.
http://www.heyco.com/products/sec_03/3-13.html
2009-03-24_162411_strain_relief_bushing.prt.zip
I have searched and read, and read and searched some more and haven't been able to figure out how to do this. I have a strain relief bushing that is modeled up as it comes from the mold, but now I want to bend it into an 'installed' position. Is a spinal bend the right option for this? Any help would be greatly appreciated! The link below is to the actual part.
http://www.heyco.com/products/sec_03/3-13.html
2009-03-24_162411_strain_relief_bushing.prt.zip