Hello-
I'm about 3 months into Solidworks. For the most part I have learned what I have needed to getme to this point. Now I'm struggling on the Tapping parts. What I'm trying to do is make a 3/4" threaded pipe. Simple I'm sure but for the life of me I can't figure it out. Can someone help from start to finish?
Any help would greatly be appreciated.
If you would like to send a sample for me to break down, please do so.
Thank you,
Brandon
I'm about 3 months into Solidworks. For the most part I have learned what I have needed to getme to this point. Now I'm struggling on the Tapping parts. What I'm trying to do is make a 3/4" threaded pipe. Simple I'm sure but for the life of me I can't figure it out. Can someone help from start to finish?
Any help would greatly be appreciated.
If you would like to send a sample for me to break down, please do so.
Thank you,
Brandon