So how can I get SMT_FLAT_PATTERN_WIDTH and LENGTH displayed in a note on a drawing? What am I missing?
Nice parameters if I can figure out how to use them.
It looks like this is a feature parameter, which I can show by &SMT_FLAT_PATTERN_WIDTH:fid_XXXX. The problem is XXXX will vary and I want to put this in a standard note.
Edited by: smores
Nice parameters if I can figure out how to use them.
It looks like this is a feature parameter, which I can show by &SMT_FLAT_PATTERN_WIDTH:fid_XXXX. The problem is XXXX will vary and I want to put this in a standard note.
Edited by: smores