Hello,
I'm having trouble plotting out detailed drawings out of ProE Wildfire 2.0. It takes 3-5 minutes to just send the file to the plotter. I'm using an HP 450C Designjet.
Wildfire creates a 2-3 meg file for a C size drawingbut when converted to a dwg file the file size is 33k.
When trying to send the dwg file out of Wildfire to the plotter, Proe converts it back to a 3-5 meg file again and takes the same amount of time to plot. Of course the ProE drawing when coverted to dwg lost some of the text alignment and the line quality was not as good.
Does anyone have any suggestions. I've tried to convert to PDFs but the file sizes are just as large and take the same amount of time. I used PDF creator for the PDF converstion.
I'm having trouble plotting out detailed drawings out of ProE Wildfire 2.0. It takes 3-5 minutes to just send the file to the plotter. I'm using an HP 450C Designjet.
Wildfire creates a 2-3 meg file for a C size drawingbut when converted to a dwg file the file size is 33k.
When trying to send the dwg file out of Wildfire to the plotter, Proe converts it back to a 3-5 meg file again and takes the same amount of time to plot. Of course the ProE drawing when coverted to dwg lost some of the text alignment and the line quality was not as good.
Does anyone have any suggestions. I've tried to convert to PDFs but the file sizes are just as large and take the same amount of time. I used PDF creator for the PDF converstion.