2009-11-12_114657_slot_centers.zip
I have created slots in a sheetmetal part. I then added a centerline (axis point) to the center of the slots.
When I get to the drawing phase, the formed view shows the center line correctly but the flat state shows the center line in correctly. (see attached pdf)
How can I make the center lines show up correctly in the flat state?
I have created slots in a sheetmetal part. I then added a centerline (axis point) to the center of the slots.
When I get to the drawing phase, the formed view shows the center line correctly but the flat state shows the center line in correctly. (see attached pdf)
How can I make the center lines show up correctly in the flat state?