sketcher decimal places for inch and metric parts

[tdx99]

Hi Everyone,

Is there any way to set the sketcher decimal place specific to the part and not the Creo 2 session?

I often work with both metric and inch parts and constantly need to reset the sketcher decimal place to 3 for inch part and 2 for metric part. I have created mapkeys to automate the change, but I wondering if there is a way (config option?) to set each part to the right value and have it locked to the part to eliminate having to use the mapkeys.

Any ideas?

Thanks.

 

[hobby_man]

Like autocad did/does 20 years ago where you can have a dimension style for each part.
LOL

PTC says no one dimensions prints anymore.

 

[dross]

Use a different config file and detail file for inch versus metric parts.

 

[dr_gallup]

I have to use both sets of units depending on the project. By default all our settings are for metric but when I have to use inch I load a config.pro file that changes all the settings for template files, drawing dtl files, etc.