Excuse the newbitry please.
I was given an extruded rectangular solid that has hole locations all
marked out. I need the hole locations for my part is basically a angled offset adapter. I'm using the solid as one side of the adapter. However, once I take the hole locations off the given
sketch with "create sketch from selections", I no longer have the parent/child
relationship to the extrusion and my sketch "disappears from the extrusion surface.
How can I
do about relating this new sketch to the surface of the extrusion so
the relations are there as I add more sketching on this part?
I've been searching high and low and can't make any headway.
Thanks in advance.
I was given an extruded rectangular solid that has hole locations all
marked out. I need the hole locations for my part is basically a angled offset adapter. I'm using the solid as one side of the adapter. However, once I take the hole locations off the given
sketch with "create sketch from selections", I no longer have the parent/child
relationship to the extrusion and my sketch "disappears from the extrusion surface.
How can I
do about relating this new sketch to the surface of the extrusion so
the relations are there as I add more sketching on this part?
I've been searching high and low and can't make any headway.
Thanks in advance.