Guru's,
I have two rather large assembly models that when
checked out from CS into a new WS and opened on my
workstation throw me into failure diagnostics. It behaves
the same way on at least one other persons pc as well.
However, the person that made the last change to the part
model that is causing all the problems has the same rev and
version of these same models open without issue on his workstation.
Anyone have any ideas as to why this is happening?
Pro/E 2001 - 2003400
Pro/I 3.2 - 2002270
TIA,
Brad
I have two rather large assembly models that when
checked out from CS into a new WS and opened on my
workstation throw me into failure diagnostics. It behaves
the same way on at least one other persons pc as well.
However, the person that made the last change to the part
model that is causing all the problems has the same rev and
version of these same models open without issue on his workstation.
Anyone have any ideas as to why this is happening?
Pro/E 2001 - 2003400
Pro/I 3.2 - 2002270
TIA,
Brad