I am routing wires to a D-sub connector. This connector was modeled with 1 entry port in the center of the connector. When I set the entry port parameter to "FLAT", it routes the first wire to the entry port, and all subsequent wires to the left of the 1st wire. Therefore, all of the wires are routed off-center on the connector.
Is there any way to change this so that the wires sort of straddle the entry port in the center? I was shown this a long time ago, but can't remember how to do it. As I recall, it had something to do with the "packing" option, but that's all I can recall.
Any help would be very appreciated. Thanks!!!
Is there any way to change this so that the wires sort of straddle the entry port in the center? I was shown this a long time ago, but can't remember how to do it. As I recall, it had something to do with the "packing" option, but that's all I can recall.
Any help would be very appreciated. Thanks!!!