MFegenbush
New member
Using WF2 here, and I can't seem to get the roughing sequence to
actually ramp into the part. I change the "CLOSED_AREA_ENTRY"
parameter to ramp, and there is no difference. My part has two
pockets and an open section. I just want it to ramp at a shallow
angle, but it doesn't seem to want to. Argh...
Thanks
actually ramp into the part. I change the "CLOSED_AREA_ENTRY"
parameter to ramp, and there is no difference. My part has two
pockets and an open section. I just want it to ramp at a shallow
angle, but it doesn't seem to want to. Argh...
Thanks