Hi!
I've been trying to assemble a few parts to animate them as a sliding garage door. The parts are the bus bar (for both sides) and the door module. The thing is, I am trying to mate the parts so that later in assembly motion i would be able to slide the connected door modules along the bus bar. What I used was coincident mate between two edges of door modules, a coincident mate between the face of a module and the bus bar and a path mate between a point on the door module and the inner-edge of the bus bar. While animating, the modules (abt 10) get messed up and the animation is a wreck. There are no mate errors though. Any ideas would be appreciated!
I've been trying to assemble a few parts to animate them as a sliding garage door. The parts are the bus bar (for both sides) and the door module. The thing is, I am trying to mate the parts so that later in assembly motion i would be able to slide the connected door modules along the bus bar. What I used was coincident mate between two edges of door modules, a coincident mate between the face of a module and the bus bar and a path mate between a point on the door module and the inner-edge of the bus bar. While animating, the modules (abt 10) get messed up and the animation is a wreck. There are no mate errors though. Any ideas would be appreciated!