Buckmurdoc
New member
Hello, I'm very very new to solidworks and i am really in need of help.
I need to figure out how to make a punched out tab, I may not be explaining this properly so i'm going to include a picture. I understand bending a little bit but i'm just looking for the easiest way to make this tab.
yes this is a picture from solidworks, i have imported a dwg file.
http://www.soleilsys.com/anjungleman/punchedtabss.gif
Any help would be great. Thanks
http://www.soleilsys.com/anjungleman/punchedtabss.gif
I need to figure out how to make a punched out tab, I may not be explaining this properly so i'm going to include a picture. I understand bending a little bit but i'm just looking for the easiest way to make this tab.
yes this is a picture from solidworks, i have imported a dwg file.
http://www.soleilsys.com/anjungleman/punchedtabss.gif
Any help would be great. Thanks
http://www.soleilsys.com/anjungleman/punchedtabss.gif