I am doing an assy. drawing and I added a end view of my motor, then a projected cross section view that was a total align (not a straight section), then whenI try to add the other end view, it will only give me the side view again?? Anyone seen this before? What am I doing wrong?
It will give me the end view if I don't section the center view.
So then I try to redefine this middle view and make it a section...and I can't get a total align...
It's like you can only get a total align if you choose it when you are making the view.
Help!
It will give me the end view if I don't section the center view.
So then I try to redefine this middle view and make it a section...and I can't get a total align...
It's like you can only get a total align if you choose it when you are making the view.
Help!