Problem w/ Mechanism Recognizing Servo

[makopolo]

I am using mechanism to display the motion of a suspension and am runing into the following proble.


When I add the servo and specify its driven entity as a point or plane it will not show up on the analysis as a posible motor to add. I can only add it when it is aplied to a joint axis.


I would really appreciate some insigt on this matter.

 

[Israr]

Point plane servo is well explaned in ptc mechanism docmentation. The example there is hand pump.


I have this solution, if you need I can send it.


Israr
Edited by: Israr

 

[daveyk_belgium]

Hello Makopolo


I had this problem in the past.


Such drivers need an analysis typecalled "repeated assembly"


Have fun


Dave