Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Register Log in

Pro/MESH

fabiogeraci

New member
Hello,



I have seen a lot of talking about Pro/Mesh, but i could not figure out
how to activate and this module on pro/engineer wildfire 2.



Thanks
 

ghareeb98

New member
After you launch ProM and after the units window, you'll get the Model
Type window with a check box for FEM Mode. Select the box and proceed.

Pro/MESH will allow you to setup the model with constraints, loads,
material properties, analysis, ....etc. , create an h-element mesh,
export the whole thing and solve it in ANSYS or NASTRAN, then retrieve
and view the results in a ProM-like window/interface.

This is helpful if you don't want to deal with the GUI of the other solvers.
 

Sponsor

Top