post processor speed

[dibz]

Hi dear all i have a 3axis post processor for the controller heidenhain tnc 426.it is a good working processor. but the problem is it takes too much time to generate the g codes .and it doesnt output pprint settings. any one could help me?.
Edited by: dibz

 

[appinmi]

I do not know why it takes so long. I have a post for the TNC-430 which has to convert all of the canned cycles to the "G200" formats with all of the "Q200" variables and it doesn't take much longer than a normal post.


What does you PPRINT commands look like? The TNC-430 has the PPRINT lines starting with a ";" with no line numbers

 

[dibz]

It doesnt produce pprint commands at all. if you wish i will send it to in your mail

 

[appinmi]

Sure, send it to me and I will look at it. What I meant above was what is the PPRINT supposed to look like?

 

[sohail abbas]

Hi


Go to the NC Post Processor and follow the path,


Application>NC Post Processro>Advanced>Commen>INTCOM>


Enter the value 484 you will see the default value for this variable is 72


Set this value as 71 and enjoy.


If still there exist any problem you are free to ask any question.

 

[dibz]

No dear it doesnt work.can you plz send me an email so that i can send it to u..
my id is
[email protected]
thanks

Edited by: dibz

 

[appinmi]

I have looked at your post processor, and the reason it takes so long to generate the code is because you are reading every line and then converting the code into "conversational" programming. If you want to speed this up, you will probably have to generate standard ISO code, (regular G & M codes). On the TNC-430, all we had to do was add the ".h" extension to the filename.


Your PPRINTS were not being output because they were not turned on in your "OPT" file. Also, the FIL macro that you had for PPRINT wasn't outputting them to the tape.

 

[dibz]

Thanks dear
It works very well. Thank you very much
i was not able to find out these things

 

[sohail abbas]

Hi dibz


If still it doesn,t work then check your PPrint options, you must make it on.


my email is [email protected]


here i am uploading the post which is 100% working download it.


if still any problem contact me


2006-06-06_015848_Post.rar

 

[dibz]

Hi sohail ur post works very well it is very fast also.

Edited by: dibz

 

[sohail abbas]

so Enjoy

 

[cncwhiz]

DIBZ,


You need to change the "Dear" part in your thread. In english this is how you address your wife or close family member?

 

[dibz]

Hi mr cncwhiz,
this forum forum like a family only,
so all are our brothers and sisters,ok
and more ever this is a technical discussion forum, so plz donot giv much importance to the language or grammer.

Edited by: dibz

 

[sohail abbas]

so enjoy dear


any thing more, you can ask me.

 

[sohail abbas]

CNC WHIZ


i think so i don,t need to say any thing more after the dibz saying.


i can change this word, but the suggestion will be at your own my "DEAR"

 

[cncwhiz]

Perhaps if you learned how to write more people wold respond to your posts?

 

[marker4x4]

Perhaps if you learned how to write more people wold respond to your posts?

Uuuh, that's a bit harsh.... chill out dude, we're all here to help each other, not pick on the grammar!!!

 

[ozamora]

hi everyone, i have a problem with a heydenhain control beacuse it graphics my NC sequences very slow, also it doesn