Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
I am intereseted in design of plastic injection molds. Can anybody provide help like documentation including tips, tricks, step by step procedures. Since I am new in this area, I have a lot to learn.
A three plate mold is generally used when gate poisition at the side or edge of the molded part is objectionable or would likely cause no filll or exteremly hard to fill sections of the part. When used as a central fill point in a symmetrical part, it allows for uniform part filling without part weakening weld lines.
yes ur right the gate depends on type of mould as well as more on component accuracy and if u want no matk on component u can go for hot runner mould it will save wastage as well as ur cycle time ok best of luck keep going
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
