Can't seem to figure this one out.
1) Start a new part
2) Sketch on the top plane and exit the sketch
3) Make an offset plane from TOP
4) Create a sketch on the new plane and click "Normal to"
>>> 5) The orientation is 180 degrees off and the
original sketch shows up upside down <<<
I don't see any options for orienting the plane when I
create the offset. Please help.
Thank you,
Boris.
1) Start a new part
2) Sketch on the top plane and exit the sketch
3) Make an offset plane from TOP
4) Create a sketch on the new plane and click "Normal to"
>>> 5) The orientation is 180 degrees off and the
original sketch shows up upside down <<<
I don't see any options for orienting the plane when I
create the offset. Please help.
Thank you,
Boris.