sallyhoo84
New member
Hi,
I'm using the merge operation for the first time and am getting the following error message: "WARNING: One-sided edge found in MERGE. Could not intersect part with feature."
I am in assembly mode with the two parts to be merged. One part has a counterbored hole and the other part is a hole insert to be welded inside that hole. The ID/OD are the same and assembled together through an insert constraint and the bottom surface of the insert is mated to the counterbore surface.
Does anyone know what the error message means? Am I using the merge operation incorrectly?
Thanks,
Saly
Edited by: sallyhoo84
I'm using the merge operation for the first time and am getting the following error message: "WARNING: One-sided edge found in MERGE. Could not intersect part with feature."
I am in assembly mode with the two parts to be merged. One part has a counterbored hole and the other part is a hole insert to be welded inside that hole. The ID/OD are the same and assembled together through an insert constraint and the bottom surface of the insert is mated to the counterbore surface.
Does anyone know what the error message means? Am I using the merge operation incorrectly?
Thanks,
Saly
Edited by: sallyhoo84