mattakelley
New member
This is my first post on this forum, so here goes.
I am trying to figure out if there is a way to link the
"Where Used" info either in a BOM or on a drawing.
I would like the drawing or BOM of a part to display what
assembly or assemblies the part goes into if any.
Has anybody been able to successfully do this?
I am trying to figure out if there is a way to link the
"Where Used" info either in a BOM or on a drawing.
I would like the drawing or BOM of a part to display what
assembly or assemblies the part goes into if any.
Has anybody been able to successfully do this?