We currently have 'approved_by' and 'approved_date' parameters set-up in our .prt and .asm start parts.
Currently, any designer can fill in the approved by & date parameters which display on the associated drawing.
Is there a way of limiting the completion of these fields to selected users...without a PDM system! (we have too few users to warrant Intralink at this stage).
I am not very famiiar with the 'full', 'limited' and 'locked' access setting for parameters. 'Full' and 'locked' seem obvious but can a 'limited' parameter only be managed by a PDM system?
If anyone has any thoughts I would appreciate your input.
Currently, any designer can fill in the approved by & date parameters which display on the associated drawing.
Is there a way of limiting the completion of these fields to selected users...without a PDM system! (we have too few users to warrant Intralink at this stage).
I am not very famiiar with the 'full', 'limited' and 'locked' access setting for parameters. 'Full' and 'locked' seem obvious but can a 'limited' parameter only be managed by a PDM system?
If anyone has any thoughts I would appreciate your input.