Im not too sure this is the right forum to post this in, but i need to
export only the internal surface of a small length of pipe.
Does anyone
know if this is possible in UG?
We want to run some CFD on a piping
system and the CFD guys only want the interior walls of the pipe. I
have tried exporting a .step of only surfaces but that didnt work too
well. Any suggestions? (Using UG NX6)
Thanks for the help.
export only the internal surface of a small length of pipe.
Does anyone
know if this is possible in UG?
We want to run some CFD on a piping
system and the CFD guys only want the interior walls of the pipe. I
have tried exporting a .step of only surfaces but that didnt work too
well. Any suggestions? (Using UG NX6)
Thanks for the help.