insert sketch

[Lambrusco75]

How do I insert a sketch into a file

I was in a hurry and saved the sketch but exited the drawing.

Is there a way to open a new one and put it in there?

 

[mvitez]

When you are in sketcher mode you must go: Sketch -- >Data from File --> Type:sketch(-*.sec) and open your *.sec file. Scale factor should be 1 and rotating angle 0 deg.

 

[dougr]

Don't think this works for drawing mode...

 

[ptalk]

If you didn't exit Pro/E, You might can retrieve it from the session directory.

 

[nkpham]

If you are using intent manager, you can do what mvitez said. if you have intent manager turned off, you can use Sec Tools> Place Section. Hope this helps....

 

[Lambrusco75]

thank you very much

 

[donha]

Does anyone know how to insert the sketch into a drawing? I have tried to no avail. You can Copy from Drawing to the sketcher, but do not seem to be able to copy the sketch to the drawing. I am running on UNIX which may make my circumstance different.

 

[dougr]

Create a datum-curve from your sketch in a part or assembly and use that..

 

[magi]

go t o part create th efeature and use append to model to insert sketch