mazzman912
New member
Is there a way to use coordinates to place parts when
brought into an assembly? I have an excel file with 4
coordinates for each corner of a rectangle. I will pull
from the 2 similar rectangular parts, alternating their
stacking, and I hope to position them based on this data
in the excel file. Is there a way to do this? The
stacking is independent of the coordinates, which are
only x and y coordinates, so think of it as a top view.
Ideally I would like to just import the data and let
Pro/E do it automatically but I'd be happy if I could do
one at a time as well. Any suggestions??
Thanks
brought into an assembly? I have an excel file with 4
coordinates for each corner of a rectangle. I will pull
from the 2 similar rectangular parts, alternating their
stacking, and I hope to position them based on this data
in the excel file. Is there a way to do this? The
stacking is independent of the coordinates, which are
only x and y coordinates, so think of it as a top view.
Ideally I would like to just import the data and let
Pro/E do it automatically but I'd be happy if I could do
one at a time as well. Any suggestions??
Thanks