I'm trying to import a spline line into WF4 into a sketch without it throwing a wobbly and moaning that their are too many entities with intent manager on.
I've tried various things, as has been mentioned elsewhere for example importing into a drawing and then deleting control points or redrawing a new ProE spline over the imported one, but still when I go to import into a sketch, within a part I still essentially end up with a lot of very small straight lines.
I have tried various splines from other sources and using differing translation formats, dxf, dwg, igs etc but no luck.
I'm trying to import aerofoil sections from Profili......
I've tried various things, as has been mentioned elsewhere for example importing into a drawing and then deleting control points or redrawing a new ProE spline over the imported one, but still when I go to import into a sketch, within a part I still essentially end up with a lot of very small straight lines.
I have tried various splines from other sources and using differing translation formats, dxf, dwg, igs etc but no luck.
I'm trying to import aerofoil sections from Profili......