I've got a flex-circuit that I've modeled as a sheetmetal part. I'd like to add surfaces to show pads and traces. I did an unbend all to flatten the model and then drew in a surface that crossed two bend lines. When I unbend all the surface remains flat. Is there a way to apply one surface around bends?
View attachment 26
Also, you can see the round pads at the bottom look crisp and clear whereas the square pads at the top are washed out with the surface of the part. The round pads are floating .005 off the surface of the part. Is there a better way to accomplish this effect?
Bernie Hayden
XKL LLC
View attachment 26
Also, you can see the round pads at the bottom look crisp and clear whereas the square pads at the top are washed out with the surface of the part. The round pads are floating .005 off the surface of the part. Is there a better way to accomplish this effect?
Bernie Hayden
XKL LLC