Hole of Relief

[amd450]

I would like of do some hole of relief around the cogwheel, I created by Cut>Extrude>...>...>Make Datum (here I created a new plane)>Setup New (to change the plane of cut). Only after that all I will go in Pattern. In resume not there other way (faster ou easer) to me do this?



Thanks in Advance



Andre Almeida

 

[xcad]

Hello,



I don

 

[amd450]

I got do the pattern, but I thought that this is very lingered in relation with others softwares hereby that I asked if there is a way easier or faster.



Andre Almeida