Hole chart using EMX

[wankhedear]

Dear PRO/E USERS,


This is regarding to Hole chart using EMX.


Can anybody give information ,how to put tolerance or fit (e.g H7) for a particular type of bore ?

 

[whit2498]

what size is the bore?

 

[wankhedear]

Dear whit2498


Assume dia 5 ejecter pin hole in cavity plate.

 

[stefanba]

Hi wankheadear,


you need to set the holechart config option TOL_OUTPUT to 1 and add a column with the lower tolerance value of the diameter dimension to the table. Then you should see the tolerance if you set this in Pro/E.


stefanba