Help on shrinkage

[Torr_Coulthard]

Any help would be greatly appreciated!
<?:namespace prefix = o ns = "urn:schemas-microsoft-comfficeffice" />
Is it possible to apply shrinkage to a donut shaped part so that the section of the part will be scaledbut the inside diameter will remain the same?

 

[vishnushankar]

Hi Torr,


If the part is as simple as you have described. Then what you can do is to use the option. shrinkage by dimensions... then what you can do is apply the shrinkage value to each x-section dimension and not the onewhich is defining the ID. Hope this should help.


Regards


Vishnu

 

[jrobi]

my thoughts exactly...