G43

[the_real_jat]

wasup


i have a G43 H01 Z -1.0 X1. Y1.2 R .05 F 20 .. i guess not sure about the XYRF paramenters here.. but is there any way in the FIL, i can split this statement into two. The first being G43H01Z-1.0 and the rest in next line.


~JAT

 

[marker4x4]

wasup


i have
a G43 H01 Z -1.0 X1. Y1.2 R .05 F 20 .. i guess not sure about the XYRF
paramenters here.. but is there any way in the FIL, i can split
this statement into two. The first being G43H01Z-1.0 and the rest
in next line.


~JAT

I suppose that this movement is RAPID and you use GPost? If so, try to set this :

Motion--> Rapid-->Motion Analysis-->XY rotary then Z



I hope it helps

-mark

 

[the_real_jat]

thanks mark


that helped to some extent.

 

[marker4x4]

thanks mark



that helped to some
extent.

Oh... what's left then?

-mark

 

[LMACHINE]

Try putting a positive value in the post processor tool change coordinate for theZ axis.And also that inyour worcell theCL output option "FROM" is set to only at start.

 

[the_real_jat]

wasup


changing to CL output option "From" to only at start option works better.


thanks