When modeling a SW sheet metal part (using legacy AutoCAD drawings as the dim refernces), the FLAT config islonger inwidth to what the AutoCAD drawing states it as. Of course, this means that the sheet metal part in SW isn't what the REAL WORLD FLAT is either. I understand K values, bend allowances, etc, factor in here. My question is: Is there a standard rule I can use to hit both sets of dims (Folded and Flat) . There is no one capable of telling me the values I need to input into SW here at the plant, so am I just going to have to figure it out by trial and error? I hope you can help