Fillet

[kevinlamers]

Everything has worked out, except one thing.
I want to make a fillet at the wing tip. but it isn't working, whatever I try.
The trailingedge is about 0.4mm and the rest of the end section is a closed loop.
I want to do a full round fillet or something that will look the same.

Kevin
http://img145.imageshack.us/img145/5269/48550544qx7.jpg
http://img244.imageshack.us/img244/5701/63652222gu5.jpg

 

[ttraser]

CAN YA SEND THE FILE? OR A SECTION OF THE WINGTIP? [email protected]


good luck. ..

 

[kevinlamers]

You've got mail!

 

[c_thompson_68]

Assuming the fillets on the leading edge and training edge are correct, have you tried a full round (through the top, side, and bottom surfaces) on the wing tip?

If the wing is just a surface model (no solids), you could also try using a fill surface. Without seeing the actual CAD file, I am limited in the suggestions I can offer.

Regards,

Chris


Edited by: c_thompson_68

 

[kevinlamers]

The model is a solid made with a loft of several cross sections. Because the sections are made of one spline (upper and bottom together) and a small straight line at the trailing edge, I dont have an upper and bottom surface. They are just the same. I think there is the problem.

Kevin