Mech_Engineer
New member
I inserted a standard fastener from a configuration from Toolbox in an assembly. This was a Pem insert which is configured for length, thread, dia etc. After saving the assembly SW dialog box prompted to save the fastener. I did not save the fastener and the assembly came up into session correctly after closing assembly. The faster properties shows the model path is from Toolbox. If I right click on the Pem in feature manager Edit Toolbox definition is available. I thought Toolbox parts could not be saved as they are part of the standard Toolbox library. Why is SW asking to save a standard Toolbox that can be brought up in the assembly session stored in the Toolbox library. This could complicate revision control if mulitple parts of the same type are saved.
Edited by: Mech_Engineer
Edited by: Mech_Engineer