Hello,
On one of my drawings in Solidworks where I did a sweep, I show Sweep ->? I can't figure out how to fix this. I have done ecerything except for erasing everything below thesweep up to that point to start over. Meaning, I have a ton of cut, sweeps, etc, etc, below this problem that I don't want to erase.
Any help to fix this would be greatly appreciated.
Thank you,
Brandon
On one of my drawings in Solidworks where I did a sweep, I show Sweep ->? I can't figure out how to fix this. I have done ecerything except for erasing everything below thesweep up to that point to start over. Meaning, I have a ton of cut, sweeps, etc, etc, below this problem that I don't want to erase.
Any help to fix this would be greatly appreciated.
Thank you,
Brandon